A while back, and I can’t really remember how long ago this was, I was working in the shop and wanted a place to rest my phone where I could still see the screen. I guess I had the table saw set up because it mostly consisted of a dado cut into a piece of scrap 2×4. That piece of 2×4 was mostly likely an off-cut from when I shortened my workbench. Anyway, I’ve been using that phone rest ever since. the cut down the center enables you to charge the phone while it is in the rest, provided the rest is hanging off the edge of a surface. I eventually added some foam because the slot was too wide. More recently, I cut the bevel on the back edge so that the phone camera can’t see the rest.

The Mark 01 Phone Rest

This rest is still a great accessory in the shop, since it doesn’t really matter what happens to it, or if it gets damaged. I think the screw hole in the top is part of the original piece of scrap. This stand didn’t really look very nice in my office, though. Hence, the new one I just made from slightly nicer lumber, using the same design.

The Mark 02 Phone Rest

This one is made from some left-over cypress from the camp gate project. Yes, I still have lumber left over from that project. I think this one is much cleaner and refined. There’s a bit of boiled linseed oil on there to make the color pop.

I must have seen this design someplace. I can’t imagine that I came up with it myself. It’s just too simple and elegant. I might make a Mark 03 version from some ipe that Mr. Arimoto gave me.